Diy Gutter Planter
The front and back of each gutter piece will have 2 holes.
Diy gutter planter. Tie a knot at one end of the 10 foot rope. This will lock each segment along the suspension wire. Then thread the brace piece through the same clamp and tighten it with a screwdriver. Garden answer youtube.
Thread the unknotted end of the rope through one of the holes in the bottom of the left gutter section and then out the. Measure 12 inches of. Start by drilling the bottom holes using your drill and 3 8inch bit. Repeat threading up through the bottom hole and out through the side hole on the next two left gutter sections.
Garden answer youtube.